Ch.0.
-Disconnect SPAD 1 Signal from PHR800 Router.
-Connect SPAD 1 Signal to [[Products:PicoHa... PicoHarp 300]] without passing SPAD 2 through the router. **In this case, however, the router cable (DVI-cable) needs to be disconnected from PicoHarp300**
==... *PicoHarp 300 (SPAD 2 connected to Ch2 of the Router) Select Ch2 (SPAD 2)
*PicoHarp 300 (w/o R
lways implicitly provide routing information if a router is used. Routing information is represented by fo... hed. However, these bits are only meaningful if a router was actually used for the measurement.
Each T3 M... only autocorrelations can be calculated (unless a router is used). This can be done at the resolution R bu