position

Search

You can find the results of your search below.

Matching pagenames:

Fulltext results:

measuring_quantum_yield @howto
9 Hits, Last modified:
ple holder. * Put the sample holder into the IN-position. * Put the sample holder into the integrating s... 14-35-37.jpg?600 |}} * Select either IN or OUT position **Note:** The sample holder has two indexed positions. When in the IN position, the excitation beam will directly hit the sample, when in the OUT position the s
fluorescence_correlation_spectroscopy-_a_short_introduction @general
5 Hits, Last modified:
uestion: \\ ** how far inside the sample can one position the focal volume and still get a reasonable FCS c... \\ __the deeper into the measurement medium one positions the detection volume the more distorted the volu... inside the droplet at which the focal volume was positioned. It can be readily seen that although for the w... objective the parameters are independent of the positioning of the volume inside the droplet drastic effec
lifetime_component_decomposition_phasor_plot_analysis
2 Hits, Last modified:
Upgrade Kit on Nikon AX: Lifetime Component Decomposition in Phasor Plot ====== {{ :Lifetime Component Decomposition in Plasor Plot.mp4?1000 |}} **Introduction** F
some_origins_of_multiexponetial_decays_for_single_dyes
2 Hits, Last modified:
place. Hence the system is always in its starting position $(A + X)$ prior to any excitation pulse.// //Cas... 1 state and brings the system to a more favorable position. Spectroscopically, this is manifested by the tim
pattern_matching @howto
2 Hits, Last modified:
composing the overall decay, it performs the decomposition on each pixel. The linear decompositions of the particular pixels give different αi's for every pixel.\\ Af
interfacing_time_resolved_spectrometer_fluotime_300_microscope_microtime_100
1 Hits, Last modified:
ding emission spectra of TRES spectra on selected positions within a FLIM image. {{youtube>NCli5MqiFic?larg
2ffcs @howto
1 Hits, Last modified:
the time trace oscilloscope optimize the pinhole position **with** Nomarski Prism and **both** lasers.
align_beam_backreflection @howto
1 Hits, Last modified:
ch quadrant. To reach this, you have to precisely position the beam to enter at the center of the objective
diamond_nv_centers @howto
1 Hits, Last modified:
w NV-centers (see figure 5), *select one, and position the focus on the NV-center. *use the oscillos
how_to_measure_the_instrument_response_function_irf @howto
1 Hits, Last modified:
or upon changes of the excitation wavelength, the position of the IRF can shift slightly, but this is accoun
how_to_work_with_the_instrument_response_function_irf @howto
1 Hits, Last modified:
power of the laser changes the shape and temporal position of the laser pulse. ((You can use the driver sett
intensity_time_trace_analysis @howto
1 Hits, Last modified:
return from the end of the line to the line start position is done with highest possible speed. In contrast,
select_the_correct_pinhole_size @howto
1 Hits, Last modified:
ger than the image of the [[wp>Airy Disc]] at the position of the pinhole: $$d_{Airy} = (1.22 * lambda / N.
using_the_antibunching_script @howto
1 Hits, Last modified:
lly moves the red and yellow curve to the correct position. Press "Calculate" again to recalculate the corre
microtime @products
1 Hits, Last modified:
or 2D- and 3D-lifetime imaging and accurate point positioning * Two optional exit ports for additional har
symphotime64 @software
1 Hits, Last modified: