Search

Fulltext results:

antibunching_measurements @howto

6 Hits, Last modified: 15 months ago

Ch.0. -Disconnect SPAD 1 Signal from PHR800 Router. -Connect SPAD 1 Signal to [[Products:PicoHa... PicoHarp 300]] without passing SPAD 2 through the router. **In this case, however, the router cable (DVI-cable) needs to be disconnected from PicoHarp300** ==... *PicoHarp 300 (SPAD 2 connected to Ch2 of the Router) Select Ch2 (SPAD 2) *PicoHarp 300 (w/o R

t3-mode @glossary

3 Hits, Last modified: 10 years ago

lways implicitly provide routing information if a router is used. Routing information is represented by fo... hed. However, these bits are only meaningful if a router was actually used for the measurement. Each T3 M... only autocorrelations can be calculated (unless a router is used). This can be done at the resolution R bu

supported_mt200_pc_configuration_for_symphotime_64 @software

1 Hits, Last modified: 22 months ago

oHarp 300=== * For imaging, only supported with Router PHR800 * Supported for point measurements (e.g.

tcspc_external_markers @support

1 Hits, Last modified: 4 years ago

and 67-68 . (For the combined use with a PHR800 router also take a look at the PHR800 manual for additio