Search

Fulltext results:

antibunching_measurements @howto

6 Hits, Last modified: 18 months ago

PicoHarp 300]] without passing SPAD 2 through the router. **In this case, however, the router cable (DVI-cable) needs to be disconnected from P... *PicoHarp 300 (SPAD 2 connected to Ch2 of the Router) Select Ch2 (SPAD 2) *PicoHarp 300 (w/o Router) Select Ch1 (SPAD2) *HydraHarp 400 select ... it is in the region of -15000 (15 ns) due to the router. *However to move the expected "dip" to

t3-mode @glossary

3 Hits, Last modified: 12 years ago

lways implicitly provide routing information if a router is used. Routing information is represented by fo... hed. However, these bits are only meaningful if a router was actually used for the measurement. Each T3 M... only autocorrelations can be calculated (unless a router is used). This can be done at the resolution R bu

tcspc_external_markers @support

1 Hits, Last modified: 6 years ago

and 67-68 . (For the combined use with a PHR800 router also take a look at the PHR800 manual for additio

supported_mt200_pc_configuration_for_symphotime_64 @software

1 Hits, Last modified: 4 years ago

oHarp 300=== * For imaging, only supported with Router PHR800 * Supported for point measurements (e.g.