howto:antibunching_measurements

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
howto:antibunching_measurements [2025/04/09 14:00] – [How to Perform Antibunching Measurements] oschulzhowto:antibunching_measurements [2025/04/09 14:01] (current) – [How to Perform Antibunching Measurements] oschulz
Line 5: Line 5:
 ====== How to Perform Antibunching Measurements ====== ====== How to Perform Antibunching Measurements ======
  
-Antibunching Measurements are (normally) measured in T2 mode. In T2 mode, all input channels of the TCSPC electronics are treated the same, also the "Sync" channel. Therefore the sync has to be disabled either by disconneting the cable, or by changing the CFD level or trigger level to such a value that the sync is not recognized any more. i.e. Sync rate = 0 . Directly in the Sepia software, the sync out can also be disabled.+Antibunching Measurements are (normally) measured in T2 mode. In T2 mode, all input channels of the TCSPC electronics are treated the same, also the "Sync" channel. Therefore **the sync has to be disabled** either by disconneting the cable, or by changing the CFD level or trigger level to such a value that the sync is not recognized any more. i.e. Sync rate = 0 . Directly in the Sepia software, the sync out can also be disabled.
  
 The descriptions below only mention physically disconnecting the sync. This is strictly necessary only for the PicoHarp 300 because it only has two channels. The descriptions below only mention physically disconnecting the sync. This is strictly necessary only for the PicoHarp 300 because it only has two channels.
  • howto/antibunching_measurements.txt
  • Last modified: 2025/04/09 14:01
  • by oschulz